What Happens During an OBD Remap in Birmingham?
By Kamran Sayed — 15 years' experience
During an OBD remap the technician connects to the diagnostic port, reads the software from the engine control unit, and writes the revised calibration back through the same port. The control unit stays fitted in the car for the whole visit. Afterwards the technician explains what was changed, and the car is ready to drive as normal.
Arrival and the first checks
The visit starts where the car is parked, at the driver's home or workplace in Birmingham. The technician confirms the car's details against the booking, so the work about to be done matches the vehicle in front of them.
The diagnostic port is then located — usually beneath the dashboard — and the equipment is connected to it. This connection is the link to the engine control unit for the rest of the visit, and it is made without disturbing anything else in the car.
Reading, then writing the software
With the connection in place, the software is read from the control unit. That read records the calibration the car arrived with, and it is the reference for the revised calibration that follows.
The revised calibration is then written back through the same port. The control unit keeps the new instructions once the equipment is disconnected, and the engine will follow them from the next start onwards.
The final checks and handover
After the write, the technician checks that the unit is responding as expected and that the car is ready to drive. The equipment is disconnected from the port, and the visit moves to the handover.
The handover is a plain explanation of what was changed, given before the technician leaves. Drivers can ask anything they are unsure about at this point, and the visit is only finished once the explanation has been given.
Related guides
Related services
Questions about your remap? Ask us
Call or WhatsApp 07367 634032 — Open 24 hours, 7 days a week.
Frequently asked questions
What happens first during an OBD remap?
The technician confirms the car's details, locates the diagnostic port — usually beneath the dashboard — and connects the equipment to it. The connection links to the engine control unit for the rest of the visit.
Is my car's software read before it is changed?
Yes. The software is read from the control unit first, so there is a record of the calibration the car arrived with. The revised calibration is written back through the same port afterwards.
Do I need to do anything during the remap?
No. The technician carries out the work where the car is parked, and you need only be available at the agreed time. The technician talks you through what was changed before leaving.
What happens at the handover?
The handover is a plain explanation of what was changed, given before the technician leaves. It is part of every visit, and it is the right time to ask anything you are unsure about.